Rob, I think that's it! I did not see the fork or how it works to move the plunger until this morning. The bearing at the fork pivot is in fact all gummed up. I have dripped some oil and some PB blaster in there and have worked it back and forth a little. The pin is beginning to move now though not ...

Thank you so much. I do believe I might need to buy a service manual as I feel kinda bad asking for help without that reference. What is "ALL the way up"? The end of the thing that pushes the record stops about an inch or so before the end of the sleeves in the rack. I cannot manually move...

Thanks for the reply. I am seeing a symptom in your book of "Mech plays the whole record side over without scanning. The safety plunger has not reset" I assume that is my symptom. I do not have a defective record as it does it on all selections. I also do not have two records in the same s...

Hello. This is my first post here. I will try not to be an idiot :) I have a Seeburg 100-77D that was out of service for several years and perhaps moved improperly. The mechanism would not move when I got it but manually spinning the motor a few times got it lubricated enough that it will scan now. ...