Hey Ron. I am back at it. With the clutch shifter I can get it to grab a record, but when it locks it in and the tone arm is set it shuts down. Any help would be appreciated. Thanks Dan...

Does any one know what would cause the phono to shut down after it loads a locks a record iN? thanks Dan....

Ron, do you know where I could pick up a manual for this unit? Dan

Hey Ron. I helped the turntable into a spin and it released. It scanned down and picked up 2 records that were in the same sleve and started playing. I hit the rejected button and pulled the records out. Now the problem is it scans up and down but wont pull a record, Dan

Thanks Ron. Gave it a try no luck just a lot of buzzing noise. I did notice on the tormat control center that there are 2 terminals that read GND record return with nothing hooked to them. Ran a ground wire to one of the terminals that the screw was loose thinking there once was a ground wire there....

Hey guys thanks for all your help, as you can tell I am new at this. The question I have now, is that I followed the wiring from the reject switch to the amp, and notice that one wire went to a terminal labeled WHT. and the other wire to a ground labeled BLK, leaving a terminal labeled BRN open. Doe...

Ron found the record arm pin it is in the in position.... Dan

Hey Ron, not sure where the record arm pin is located or what it looks like. I am going at this blind with out schematics, or manuals. The tone arm does swing freely. Dan

Ron, Thanks for helping me on this. This is what I can make out tsa 1 code E the fuse looks good. Waiting on a neighbor to bring down a fuse tester. Their is a loose ground wire coming from the back wall of the unit cant tell where it is supposed to be connected to on the amp, but the railing that t...

Ron the amp fuse is 8/10 model no. lpc480 dt amp type sn- 8 code S O 65 not totally sure tough to read. When the arm is foward it still gets sound, also notice ground wire not connected could that be a problem for fuctioning.

Hey Ron. I am getting audio when I touch the needle. But I also noticed a wood screw fell out of one of the units. Which I dont think it is supposed to be there. Just wondering if it was being used to hold something into Place. Thanks Dan

Hey Ron. I do have audio when I touch the needle. I did notice a wood screw that fell out of one of the units I am wondering if was used for holding something up. Thanks Dan

Thanks for getting back with me Rich. Tried the reject button nothing doing but a buzzing sound. The fuse I replaced was the 6.25 ceramic fuse for I guess it would be called the power box. But I replaced it with the same kind that was previous in there. All the tubes seemed to be working. They feel ...

New to the forum. I picked up a 1964 lpc480 for free, taking up space in a friends garage. It would not power up,so I replaced the fuse and that seemed to do it. The problem is that it went to pull a record that was not its sleve and tried playing it. The motor seemed to be running find. But now it ...