I just replaced the red one with the blue green one.

I figured I'd start a post about the pickering 345 cartridge needles. I'm looking for the best set I can find. The last pair I got I'm not happy with. My juke has some distortion in the vocal range. I have replaced the tone arm wire, adjusted the mech and had the amp rebuilt and still It seems to be...

Would used non worn out needles be a better option? I think I have the set that came with the box. By the look of the records it may have been last used in 1998 or 99. I read they can be cleaned with good results.

Ok set screw and wire loop adjustment solved it. Plays pretty good now.I Adjusted the pick up location inwards since it was landing beyond the record too. Thanks Rob and Ron for your help!

Rob- Are you in new york? Id be interested in checking out one of the nostalgia locations you mentioned.

Ok, Im not sure which setting is the needle bearing set screw in that photo. I'll recheck what I did perhaps pull the assembly again. I was going to replace the styluses. any recommendation on a supplier? I went ebay last time, they work ok. I don't mind paying abit more for better sound quality I'v...

Does the wiring route through the cradle assembly?

I haven't really adjusted the springs yet, I only got them in place and discovered that the tone arm wouldn't drift. So still need to set it.

I swapped out the red tonearm in my 66 SS160 Seeburg. The wire at the cartridge connector had broken. I replaced it with a "Blue" colored Arm from a later model. Seems to be very similar but with better damping action. I should have taken better photographs beforehand. I now have sound fro...

Ron, ThAnk you for you quick response and instructions. too clarify the Juke does make EVERY selection, in order, if you change torrid states, with a D cell Battery. What I meant to communicate is that It will also trip and play if you connect the positive side of a battery momentarily to the TMU so...

My SS160 has been running fine for a year or so, It sees almost daily use. It has recently started to Scan 2x then stop. It was left off for a week an it began working again but after about 10 songs it started to Scan 2x then stop again. The next day it would only play 5 selections then 2..then 1. I...

It does indeed have a 5 pin din connector for a aux out

I ordered this, I hope the connection is fairly standard. 5pin din to RCA cable
http://www.ebay.com/itm/290939278118

Hello, I am having a Wurlitzer OMT 1015 being transported by an Amusement company to our wedding reception, it's the same company it was purchased by, At the event we would like to connect the jukebox to the PA system. I don't see an output on the back of the unit, but have seen that some 1015's do ...

Thank you Rob and Ron, I spent some time studying the Mech and noticed that the B side record play position the stylus was jammed too far right. the spring mount on the tone arm was upside down and not putting tension on the arm at all. I flipped the spring around and re checked the pressure and now...

Thank you Rob and Ron, I spent some time studying the Mech and noticed that the B side record play position the stylus was jammed too far right. the spring mount on the tone arm was upside down and not putting tension on the arm at all. I flipped the spring around and re checked the pressure and now...

Which pins are the left and right channel? I tried getting an ohms reading several ways before hooking up to the two front pins and then the two back pins. I say front and back pins in relation to me standing directly in front of the jukebox. I would have thought the two pins directly below each sty...

I have new needles i do believe I flipped them awhile back to no avail. Will try now again that there is less variables in the mix. My guess was the socket, cartridge or needle.