Page 1 of 1
Name es3 satellite mech problem
Posted: Wed Dec 10, 2014 12:01 am
by Armyaviation
I have a satellite with an es3 player mech and when the small are lifts the record from the back, it doesn't seat properly. It used to work but I think I messed with it...how do you adjust the arm that lifts the record
Re: Name es3 satellite mech problem
Posted: Wed Dec 10, 2014 12:19 am
by MattTech
Adjustments I'm quite sure, are covered in the service manual.
Re: Name es3 satellite mech problem
Posted: Wed Dec 10, 2014 1:16 am
by Ron Rich
Matt,
Maybe, they are covered----IF, you can read German--
Ron Rich
Re: Name es3 satellite mech problem
Posted: Wed Dec 10, 2014 3:54 am
by MattTech
Ron Rich wrote:Matt,
Maybe, they are covered----IF, you can read German--
Ron Rich
Achoooo!
I mean guzuntite... yaknowwhadimean.
Re: Name es3 satellite mech problem
Posted: Wed Dec 10, 2014 4:55 am
by Armyaviation
They are not covered
Re: Name es3 satellite mech problem
Posted: Wed Dec 10, 2014 7:39 am
by mb9513
I have ES 2 system and the mechanicals are similar. the manual gives picture breakdowns read the section "unclamping and record return" at least the English version. my manual shows the tone arm carrier and the cam that carries it back an forth for a to b side. You must make sure that everything is lubricated well. NSM used some awful stuff that was like tar, and had to be cleaned out with lacquer thinner and a que-tip.
watch as the tone arm completes its travel and trips the reject switch. it may be a matter of removing the carriage all together and manually turning the mech motor and watching what it does. for reference my manual has figure 8 on page 35 and figure 15 on page 39. hope this helps. Mark