NSM Hyperbeam Preformer ES5 Free play and FULL CD play

to program ES5 NSM for free play and to play entire CD selected
(this is for a NSM ES5, most ES5's were updated to ES 5.1. This was a free update. Programming for ES 5.1 is different)
PROGRAMMING
FOR
FULL CD PLAY AND NEW CD ADDED

1. AFTER LOADING ALL CD TITLES AND ALL CD'S
IN CD TRAYS YOU MUST TEACH THE COMPUTER
WHAT IS THERE.

2. PULL OUT PROGRAMMING SWITCH (RIGHT SIDE TOP)
3. PRESS “C” UNTIL ONLY THE LETTER “P” SHOWS IN WINDOW
4. ENTER “160 AND H”
5. ENTER “0 AND H”
6. THE MACHINE WILL NOW “READ” EACH CD AND RECORD TOTAL SONGS ON EACH CD.
7. AFTER 100 CD'S HAVE BEEN READ PRESS “C TWO TIMES”
8. PUSH PROGAMMING SWITCH IN THE PULL OUT
9. PRESS "C" UNTIL ONLY THE LETTER "P" SHOWS IN WINDOW.
10. ENTER "094 H 200 H"
11. PUSH PROGRAMMING SWITCH IN AND CLOSE LID.
12. SELECT A COMPLETE CD AND ENTER ITS NUMBER FOLLOWED BY “00” (ie: 0100)
13. THIS SHOULD LOAD AND PLAY THE ENTIRE CD
14. THE MACHINE IS PROGRAMMED TO SHOW “99”CREDITS. YOU CAN PUT MONEY IN (EITHER BILLS OR COINS) BUT THE CREDITS WILL ALWAYS SHOW “99”.
15. IF YOU SELECT AN ENTIRE CD TO PLAY AND WANT TO REJECT IT YOU MUST REJECT EACH SONG ON THE CD BEFORE IT WILL GO TO THE NEXT SELECTION.


ADDING A NEW CD

1. AFTER CD IS ADDED AND TITLE IS ADDED
2. PULL PROGRAMMING SWITCH OUT
3. ENTER “C” UNTIL ONLY THE LETTER “P” SHOWS
4. ENTER “161 AND H”
5. ENTER THE CD NUMBER. Ie : 67 H . THIS EQUALS CD NUMBER 67. THE MACHINE WILL READ THE CD AND RECORD THE TOTAL NUMBER OF SONGS.
6. AFTER IT READS TH CD AND REPLCES IT, PRESS “C TWO TIMES”
7. PUSH PROGRAMMING SWITCH IN AND CLOSE LID.