seeburg topas

hi! my Seeburg Topaz takes and plays correct selections but dont stop scanning. Scannes forever!
When I turn it on it will starts scanning again. I´have replaced the red box , but it will not help
Please give me some advise
Roland in Sweden
I also have porblems with my Seeburg Olympian , the "wandering" lamps are out of order . Perhaps I made a short cut by mistake, Is there some fuses who have blown or is it something else ?, it started when I was adjusting the sliding contacs under the Tormat memory, with power on. perheps I made shortcut with the screwdriver to ground?

On the 100-77D, if I remember correctly, the scan control unit is on the carriage front, held in place by two "O" rings.
Replace the "O" rings, and it probably will be OK. ( I stock the "O" rings--PM me if you wish to purchase a set).
On the SPS-160, you have probably blown the 1/2 amp fuse on the carriage assembly.
Ron Rich

rk05979 wrote:hi! my Seeburg Topaz takes and plays correct selections but dont stop scanning. Scannes forever!
When I turn it on it will starts scanning again. I´have replaced the red box , but it will not help
Please give me some advise
Roland in Sweden
I also have porblems with my Seeburg Olympian , the "wandering" lamps are out of order . Perhaps I made a short cut by mistake, Is there some fuses who have blown or is it something else ?, it started when I was adjusting the sliding contacs under the Tormat memory, with power on. perheps I made shortcut with the screwdriver to ground?

thanks for the advise. I´ll will make a test tomorrow
Roland