Page 1 of 1
Rowe R-92 Program
Posted: Wed Jan 14, 2009 4:14 am
by DavidD
How do I program my Rowe R-92 jukebox to save settings when I turn it off? I have to go back to the sevice mode everytime I turn it off. Also is there a way to have a CD player and have the lights blink to the music? I got a CD player and had to unplug lights from the amp to plug in CD. I just bought this Jukebox and not real familiar yet. Thanks
Re: Rowe R-92 Program
Posted: Wed Jan 14, 2009 5:56 am
by Ron Rich
I am assuming that you have an R-92 COMBO ? The Service manual or Service Manual Suppliment should give you the correct wiring for the combo input--I'm not sure, but it seems that the CD input should not go to the Aux out--perhaps I'm wrong, as it has been years since I've seen a working combo--, and if so, you should be able to insert both plugs onto the "pins" at the same time.
On the programming forgetfullness--you need to change the battery in the CCC. Ron Rich
Re: Rowe R-92 Program
Posted: Sat Jan 17, 2009 12:21 am
by bigjohn
Ron is right, but the trick is to look at the pins where you are pluging the small white connector on to. There could be a dummy plug on those pins, but its close to the printed-circuit board. Unplug the amp and reach in the opening with some needlenose pliers, and pull the fake one out. Now you can push the 2 connectors on the pins, you might need to bend the cables out of the way so the first one slides father down the pins. Change the battery.