seeburg 3wa-v dcu pricing

gamerterry · by **gamerterry** » Sat Apr 19, 2014 12:46 am

NEED HELP ...I DONT UNDERSTAND HOW TO CHANGE PRICING....MINE IS ONE PLAY FOR QUARTER....I WOULD LIKE 3 OR 6 PLAYS FOR QUARTER ...CAN YOU TELL ME OR SHOW place IN MANUAL...THANKS TERRY

by **Ron Rich** » Sat Apr 19, 2014 1:12 am

There is "no place in the manual", or any where else that will show you how to change prices on a DPU. That's because, they did not design it to be changed. If you want it to be set at the original settings ( which depended on which model DPU was installed) you will need to "figure out" what "someone" has done to change it. Once that's done, it may, or may not be, a very simple re-wiring job-- Ron Rich

gamerterry · by **gamerterry** » Sun Apr 20, 2014 5:02 am

i have a V-3WA DCU10 L-6 .... IT SAYS I SHOULD GET 3 PLAYS FOR A QUARTER ....I ONLY GET ONE PLAY FOR A QUARTER ..CAN ANY ONE TELL ME WHAT I SHOULD BE GETTING AND CAN I CHANGE IT ....THANKS TERRY

by **Ron Rich** » Sun Apr 20, 2014 4:59 pm

Please--read my "PM" to you---
As I attempted to say earlier--the factory never intended for "pricing changes" on DCU/DPU model, pricing units. Therefore, when done, it was always a "hack job"--there were different ways guy's did this, and I (nor anyone else-I don't think), can determine exactly what to do to restore it, other then to install the correct parts--which are no longer available. I would advise you to contact the "ligit" sellers listed above, as one or more MAY have an un-molested DPU for sale. Ron Rich
P.S.Also, note, that there were "two versions" of that unit--the later type "plugged in", while the earlier type was "hard wired".