Hello,
I recently purchased a matching set of Magnavox speakers and record player. All looks to be good but there are two wires with push-on terminals coming from one of the transformers that I'm having trouble finding where to connect them. I believe they are used to power the phono motor.
Thanks
Magnavox 1SP263F Wire Hook-up
Electrically amplified phonographs or radio/phonographs and related components (approx. 1928-1990).
- Attachments
-
- Screen Shot 2014-05-03 at 10.59.33 AM copy.jpg (185.03 KiB) Viewed 541 times
-
MattTech
- Senior Member
- Posts: 1461
- Joined: Tue Apr 29, 2008 7:38 am
- Location: Philadelphia Pa USA - Home Electronics - Service Technician
? 
?
?The Internet is a marvelous thing, however it's not a good substitute for actually being there.
I wouldn't do that. They look like audio transformers to me and thus should be connected to speakers, not a motor.
Vinyl is disease which attacks that area of the brain desiring digital recordings. Once you catch it, you are cured.
-
Record-changer
- Senior Member
- Posts: 1139
- Joined: Fri Apr 21, 2006 8:11 pm
- Location: Bloomington IN USA
I have a similar amp.
The three screws are the speaker outputs. If you have only one speaker, connect it to the 1 and blank terminals, and leave the jumper in place. If you have two speakers for stereo, remove the jumper, connect one speaker to the 1 and blank screws, and connect the other speaker to the 2 and blank screws.
The power for the changer motor is a 3 or 4 pin rectangular connector similar to a Molex connector, but using square pins. On mine, there are three wires from the changer:
Black: hot from line plug to switch
Yellow: power for the amp from the power switch
Red: neutral from line plug to the the motor
The three screws are the speaker outputs. If you have only one speaker, connect it to the 1 and blank terminals, and leave the jumper in place. If you have two speakers for stereo, remove the jumper, connect one speaker to the 1 and blank screws, and connect the other speaker to the 2 and blank screws.
The power for the changer motor is a 3 or 4 pin rectangular connector similar to a Molex connector, but using square pins. On mine, there are three wires from the changer:
Black: hot from line plug to switch
Yellow: power for the amp from the power switch
Red: neutral from line plug to the the motor
Who is online
Users browsing this forum: Yahoo [Bot] and 2 guests
It is currently Thu Oct 06, 2016 10:18 am