SMC1 amp rebuild

Ron,

I've already switched it over to the molex connector but I will probably order a set just to keep it original.

Update.

I finally got the resistors in to replace the bias adjustment pots. After checking all of the procedures in Tony Miller's book, both sides now have the same output strength.
I was not able to find new edge connectors or pins to re-do the connectors, so I popped the pins out one by one and cleaned them.
I've found the box sounds a little better if I crank the volume and stand back, rather than standing right in front of it.

Thanks to everyone for all their help and suggestions.

Don